The application will communicate with the vehicle computers at the 16 Pin OBD2 diagnostic connector. Most of the OBD2 connector location should be under the Steering Wheel Compartment. Elm 327 or STN Bluetooth device is required to make this application work. Car Gauge Pro not only can be exciting with gauges, it is a professional scan tool. Do you have a check engine light on? Do you want to know the Readiness Status will pass for a Smog Inspection? Do you want to check the functionality of the sensors and determine the status of the Mode 5/6 Emission On-board Test? Car Gauge Pro will show you.
✮ Mode 1 - Data Parameters with 220 PIDS
✮ Mode 2 - Freeze Frame Data
✮ Mode 3 - Check Current Faults
✮ Mode 4 - Clear Faults
✮ Mode 5 - O2 Sensor Test Result
✮ Mode 6 - Emission Onboard Test Result
✮ Mode 7 - Check Pending Faults
✮ Mode 8 - Enable Evap Test
✮ Mode 9 - Vin, ECU Name, Performance Tracking Data, CALID & etc
✮ Mode A - Check Stored Faults
✮ Ford (1996-2008) - Check/Clear Faults, Self Test, KOEO, KOER, Diesel Glow Plug/Injector Buzz/Cyl Contribution Test, Outputs On/Off, Low/High Speed Fan Test, and Enhanced Data 1175 PIDS (ISO, PWM, CAN)
✮ Nissan (2001-2007) - Check/Clear Faults, Self Test, Ignition Timing Adjustment, Idle Rpm Adjustment, Active Test and Enhanced Data 634 PIDS (KWP2000 - ECM, TCM, ABS, BCM)
✮ GM (1996-2007) - Check/Clear Faults, Active Test and Enhanced Data 189 PIDS (VPW Powertrain)
✮ Toyota (2000-2006) - Enhanced Data 150 PIDS (ISO - Powertrain) + Read/Clear Faults (KWP2000 Airbag)
✮ Kia (1996-TBD) - Enhanced Data (ISO Powertrain)
✮ Some Models may not support Enhanced Functions
Download Skins, DTC Library and Language from the website.
Hardware Requirement: Elm 327 or STN Bluetooth Adapter.
Vendors: CHX, OBDII, VGate and OBDLink MX tested OK.
Recommended for You